Roger our region s president has been doing some local autocrosses lately and i guess he got to thinking about what might happen if he tried jumping a curb at full tilt like he did one time ask him about it sometime and got it upside down.
Miata roll bar install instructions.
1 this step is my favorite part.
These pieces are called quarter trim by mazda first remove.
Using a small crow bar claw hammer or button removal tool carefully pry the plastic buttons from the carpet at the front edge of the package tray.
2 remove the trim panels covering the seat belt towers.
3 remove the lower seat belt reel bolts 16mm pre 94 17mm 94 and later and spacers.
We worked with hard dog to give you as much overhead protection as possible.
The original spacers fig 1 once the hard bar and those rascally seat belt reels are in position start but do not completely tighten the footplate mounting bolts from the hardware kit make sure that your seat belts are on the inside of the roll bar.
First part here https youtu be fwuvak1lt9u autox fun in this car here https y.
Second part of the installation of the hard dog roll bar into a nc miata.
Install the upper mounting bolts through the upper mounting plate with the spacer under the.
We offer a wide range of parts for all years of the mazda mx 5 miata.
Put the top down.
The legendary hard dog roll bars are now available for the nd chassis.
We believe there is an excellent chance this bar will fit a 124 spider but we have not been able to confirm yet.
With the top partially raised roll or fold the horizontal package tray carpet back under the convertible top.
The roll bar plates fit against the seat belt reels which stay in their original location but do not use the original spacers.
Remove the carpet and padding from the vertical wall behind the seats.
Fig hc2 once the bar and the seat belt reels are in position snug but do not completely tighten the seat belt reel mounting plates using bolts from the hardware kit and small od flat washers from the stock bolts.
This bar is legal for use with nasa.
Remove the package tray cover about ten 10mm bolts and remove the seat belts from their receptacles by prying off the plastic cap from the seat belt harness restraint and removing the 19mm iirc bolt save this bolt because you are going to reuse it to secure the bar to the top of the seat belt tower and 10mm screw on top and 17mm bolt on the bottom and lay the seat belt mechanism to the side.
Flyin miata is the world leader in miata performance.
