You can notice here that i had to lower the height to get.
Move walls attached to roof sims 3.
Now lower the roof.
I m not terribly concerned about it.
Do the same thing with the left side of the roof.
As you can see over the open reception area the roof is coming through.
Putting all the walls down allows you to place wall hangings but then you can t move them.
That above is the problem i m having.
Grab the diagonal half hipped roof and rotate it so the flat side is facing the front of the room.
I don t have any coielings but i have already tried replacing them and the two roofs either side above the bay windows don t go through either even though those rooms don t have a ceiling.
Then level the guide wall.
Start with the walls of your barn then go up a level and add another set of walls but make this set one space in along the sides.
Its a pain has no design sense at all and generally just looks lousy.
If you need a roof to extend from the house to an outbuilding for some reason but without supports down its length connect.
Using the half gable tool place a roof along the thin outer edge of the second floor on both sides and a gable roof on the top section.
Here s one with the front wall four blocks wide and the roof raised up some.
You must work with the wall to find that height again.
The other problem is a message that says can t intersect other objects this one is because something is getting in the way.
Just thought it was something that should be mentioned to the engineers.
Just add a piece of wall or a column where each corner will be and you should then be able to place the roof.
The only thing is the front wall has to be an even number of blocks wide for it to work.
You can already see where this is going.
Like this now just move into place on the right side.
Once the roof is in place you can remove the support.
Once you move the terrain under a guide wall the walls above it will again go back to normal height.